Engine needs Choke On to run
The information contained in our websites is designed as a guide only, for assisting Repair Professionals. By using our information you are agreeing to our T&Cs.
If you need to have your Choke fully or partially “On” or “Closed” to make your engine run, even after warming up the engine, then you need to perform the following steps:
1) Be sure the Air Filter is clean and in good condition. Dirt and Particles from the filter can get into your engine and carb and cause damage. Replace if necessary.
2) Check your Fuel Tank for Rusting or Contamination. To locate the cause and to prevent future clogs, be sure to also drain and inspect Fuel Tank for rusting and replace if necessary. Dirty Red or Brown fuel is a indication of a rusty tank, and this contamination will eventually seize your engine! Never run your generator on dirty fuel or a rusty tank.
3) Clean and rebuild your carb. Particles from the Fuel Tank, or that the Air Filter have allowed through, has clogged your jets and you will need to clean them out. You might need a Carb Repair Kit if you are unable to clean the jets, or there is damage to the Float, or Float Needle. Inspect parts carefully when cleaning. When you rebuild your carb be sure the Brass Air Screw with the Spring behind it, is set to 1.5 turns from fully tight.
4) If the engine will still not run correctly, please replace the Carb. The ports and passages are degraded. Be sure to have carried out step 1 and 2 before fitting a new carb, or the new carb will also stop working, and will void any manufacturer warranty.
First we need to know what the issue is with your Generator.
Did that fix your issue?
No, I need to buy parts. Take me to the “Parts Search” please.
No I need more help please.