Dual and Tri-Fuel LPG/NG/Propane/Butane/Autogas - Small Engine Revving
The information contained in our websites is designed as a guide only, for assisting Repair Professionals. By using our information you are agreeing to our T&Cs.
If your engine is revving, please check the following:
1) Check the spring on the Governor Rod. This is the rod that goes from the top of your carb to the governor arm. Check if the spring is broken, becomes slack or has come off at either end. Replace if necessary.
2) Check the Governor Arm spring. This sits between the engine and the governor arm. Replace if necessary.
3) If step 1 & 2 has failed then your governor will need resetting. This is a complicated job and we suggest is only carried out by a mechanically minded person. (You will need 2 people)
A) Person 2 – Pull gov arm to far right.
B) Person 1 holds with pair of pliers the governor spindle that protrudes from the engine, while Person 2 loosens the retaining bolt on the governor arm and lifts the governor arm straight upwards until it comes off. Do not turn the governor spindle while doing this.
C) Person 1 rotates the governor spindle as far clockwise as the spindle will turn.
D) Person 2 replaces the governor arm again in the far right position (throttle completely open) and tightens the retaining nut.
4) If all else fails you need to replace the Governor.